F un-Fold Card using Stampin’ Up! Products
Project Recipe
Base card: Thick Basic White
5 1/2” x 8 1/2” score 4 1/4”
Measure from outside edge of the
Cardstock at 1 1/4” and cut from
score line of the card base to the
edge of the card. At 4 1/4” do the
same.
Base Sides:
Basic Black 1 1/8” x 4 1/8” (cut 4)
DSP 1” x 4” (cut 4)
Glue the DSP layers to the Basic Black layers. Two will be for the front and two for the inside layer.
Window sheet (bridge) 1 1/4” x 5 1/2”
Glue to the two side flaps using Teat n Tape.
Base Center:
Basic Black 2 7/8” x 4 1/8”
DSP 2 3/4” x 4”
Glue DSP to the Black layer and glue to the center flap.
Inside:
Glue the strips of black with DSP to each side of the inside of the card.
Stamp sentiment on center
Add the two strips of black with DSP to each side flaps.
Diecut the turtle from the DSP and put Tear n Tape on the bottom half of turtle and attach to the window sheet at the left side.
Stamp the sentiment and Diecut it out. Put 2 small dimensionals at the left side and glue on the right and attach to the left side of the window sheet
Add gems as shown
Envelope Flap:
DSP 2 1/2” x 6”
Glue to envelope flap and trim