E legant card using Stampin' Up! products.
Project Recipe
Cut cardstock pieces to the following sizes using a Paper Trimmer:
- card from Fresh Freesia Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Fresh Freesia Cardstock
- 2-1/4" x 4-1/4" from Basic White Cardstock
- 2" square from Basic White Cardstock
Insert the Fresh Freesia rectangle into the Seashells 3D Embossing Folder. Place the folder with the cardstock inside on a platform on your Stampin' Cut & Emboss Machine and run through the machine.
Adhere the dry embossed Fresh Freesia rectangle to the front of the Fresh Freesia card.
As you are ready to stamp using the Friends Are Like Seashells Set, place the cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp.
Mount the conch image from the Friends Are Like Seashells Set on Block H. Ink it up with the Fresh Freesia Ink Pad. Stamp it in the center of the white rectangle.
Pick out the stitched rectangle die from the Stitched Rectangles Dies that cuts out a stitched rectangle that is 1-11/16" x 3-3/4". Put it on top of the stamped shell image on a platform on your Stampin' Cut & Emboss Machine so the image is centered in the die. Run through the machine.
Adhere the shell rectangle cut out to the center of the card front so the top of the rectangle is about 3/4" from the top of the card.
Mount the sand dollar image from the Friends Are Like Seashells Set on Block C. Ink it up with the Smoky Slate Ink Pad. Stamp onto Grid Paper. WITHOUT RE-INKING, stamp the image in the center of the small white square.
Mount the "for you" or "love you to the beach and back" sentiment from the Friends Are Like Seashells Set on an appropriate size block. Ink it up with the Fresh Freesia Ink Pad. Stamp it in the center of the sand dollar image on the white square.
Pick out the mostly round, sand dollar die from the Seaside Seashells Dies. Put it on top of the stamped sand dollar on a platform on your Stampin' Cut & Emboss Machine so the image is centered in the die. Run through the machine.
Use Stampin' Dimensionals to adhere the sand dollar cut out to the front of the card so it overlaps the lower right corner of the shell rectangle cut out.
Cut a 5-1/2" piece of the Smoky Slate 7/8" Textured Ribbon.
Tie a half knot in the center of the ribbon. Trim the ends.
Use a Mini Glue Dot to adhere the ribbon knot to the card front at a slight angle over the bottom left corner of the shell rectangle cut out.