Project Recipe
Cut your card base from Mint Macaroon cardstock 8 1/2" X 5 1/2", fold in half and use bone folder to smooth the crease.
Cut a piece of Very Vanilla cardstock at 4" X 5 1/4" and adhere to the inside of your card base.
Cut the front panel of card from Crumb Cake cardstock at 4" X 5 1/4". Adhere to front of card base, centering so you can see a bit of the Mint Macaroon around the edges.
Cut a piece of Mint and Gold Leaves Guilded Autumn DSP 1 1/2" X 4 1/2". Cut a notch on one end of the strip. Center straight edge of DSP along the top edge of your Crumb Cake panel, and adhere.
Cut a piece of Mint Macaroon cardstock at 1" X 4". Take this piece and emboss using the Wrapped in Texture Embossing Folder #2. Adhere slightly (about 1/4") above the notch on your DSP.
Cut a piece of Mint Macaroon cardstock at 1" X 4". Take this piece and emboss using the Wrapped in Texture Embossing Folder #2. Adhere slightly (about 1/4") above the notch on your DSP.
Cut a piece of bronze Brushed Metallic cardstock at 1 1/2" X 4". Take this piece and emboss using the Wrapped in Texture embossing folder #1. Adhere slightly above your Mint Macaroon embossed piece, just enough to show off both of the embossing patterns.
Now cut a piece of Very Vanilla card stock at 2 3/4" X 4". Cut out label using Stitched So Sweetly Dies. I used the largest oval shaped one.Using Cajun Craze ink stamp sentiment centered on the label. My sentiment of "Autumn Greetings" was taken from the Autumn Greetings Stamp Set. Set aside, do not adhere yet.
Cut a piece of Cajun Craze cardstock at 3 1/2" X 2 1/2". Cut a leaf using the Stitched Leaves Dies, making sure to include the center die for the beautiful stitched look. Use stampin dimensionals and adhere to the upper left corner, angling the stem to the middle of the embossed copper piece.
Cut a piece of Gold Brushed Metallic cardstock to 1" X 3 3/4". Cut a wheat accent using the Autumn Essentials Dies. I trimmed a little of the end of my wheat stem off, then figured where I wanted to place my wheat on the leaf cut out. I used my Multipurpose Liquid Glue so I was able to slide the die cut and give myself a little wiggle room for placement.
Finally take your sentiment piece, decide how you want to place it, and adhere to the front using stampin dimensionals.